Used when a wall to wall installation is not available. One or two end panels can be used - Use one end panel when a single end/side wall is available and two in a flat wall situation (Centre of the wall).
Fitting of End PanelsStep 1
Measure from the wall your ordered width dimension and mark position on
the back wall with pencil – this will be the outside face of the end
pane (A).
At this position measure the back wall dimension from floor to ceiling (B)
and also at position 610mm from the wall (front edge of end panel (C).
(See illustration, shown in next section)
If both dimensions are the same cut down the end panel to this size minus 2mm. If there is a significant difference between the sizes cut and the end panel to match the shape of the ceiling/floor.
This step-by-step guide is designed to ensure the correct Installation of the Sliding Wardrobe components.
Download Installation Guide pdf here
Step 1:
Liners and End Panels
Liners: Preparation
Step 2:
Fitting of End Panels
Step 3:
Fitting Bottom Track Liner
Wall Liner
Step 4:
Cutting Top and Bottom Track
Installing Top Track
Installing Bottom Track
Step 5:
Installing the Doors
Adjust Doors
Step 6:
Completed Installation